400G QSFP112 SR4 LPO Transceiver

400G QSFP112 SR4 LPO Transceiver

Absolute Maximum Ratings

Recommended Operating Conditions

Transmitter Optical Specifications

Receiver Optical Specifications

Pin Definitions

Figure 1 –Module Pad Layout

Notes:

1.GND is the symbol for signal and supply (power) common for the QSFP56 module. All are common within the QSFP56 module and all module voltages are referenced to this potential unless otherwise noted. Connect these directly to the host board signal-common ground plane.

2.Vcc Rx, Vcc1 and Vcc Tx are the receiver and transmitter power supplies and shall be applied concurrently. Recommended host board power supply filtering is shown in below Figures. Vcc Rx Vcc1 and Vcc Tx may be internally connected within the QSFP56 Module in any combination. The connector pins are each rated for a maximum current of 500 mA.

Figure 2. Recommended Power Supply Filter

Optical Interface and Mechanical Dimensions

Figure 3 – Optical Receptacle and Channel Orientation for MPO connector

Figure 4 – Mechanical Dimensions.

Ordering Information